top of page

ANSI Stationary Multi-Spring Single Cartridge Mechanical Seal

ANSI SEAL VSMS3/VBSMS3

 ANSI Tandem Solids Excluding Slurry Seal
Product Line Features
  • Simple cartridge seal installation.

  • Sleeve is isolated from process fluid.

  • 3/8″ NPT flush connection allows for cooling and venting of seal.

  • 1/4″ NPT vent and drain connections provide differential sizing to minimize the potential of improper piping.

  • Non-sparking throttle bushing is positively retained to avoid pressure blow out, minimizing leakage in the event of seal failure.

  • Vantage seal glands include flush, vent, and drain connections and a close-clearance, non-sparking throttle bushing to direct any leakage to the drain connection.

  • Flush, vent, and drain connections available to be piped at multiple locations.

  • Angled gland connections allow for easier pipe fitting.

  • Setting clips provide positive axial and radial setting of the Vantage cartridge seal to ensure proper seal installation. The Vantage setting clips are easy to access for simple removal.

  • Convertible gland design to accept over four (4) design configurations.



VSMS3/VBSMS3 Features
  • Stationary springs isolated from process fluids to minimize corrosion, clogging

  • Flat Drive System eliminates face drive pins enhancing face stability and reducing face fractures

  • Dynamic Drive Ring eliminates primary face hang up and reduces face to pin fretting

  • Dynamic elastomer moves on non-metallic, smooth surface eliminating fretting

  • Stationary design for optimal face alignment

  • Available in ANSI Big/Taper and Standard Bore

ANSI Stationary Multi-Spring Single Cartridge Mechanical Seal
bottom of page